This item is for the Race Tools Key Only, it allows you to enable Woolich Racing Race Tools using the stock Shift Sensor. No Hardware is included with this item.
The Race Tools package allows you to add Autoblipper, Quickshifter, Pit Speed Limiter, Engine Warm Up and Launch Control to the Stock ECU.
Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.
Autoblipper Opening and Target maps are fully configurable per gear.
Pit Speed Limiter RPM can be configured.**
Launch Control allows you to configure Delay, Launch RPM and Hold Speed.
Engine Warm up parameters are fully configurable. **
* Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length.
** This harness uses the stock exhaust valve plugs on the bike's harness, the stock exhaust valve should be removed from the bike and disabled in the WRT software
** The Pit Speed Limiter and Engine Warm Up, requires the purchase of an additional Pit Speed Limiter Harness.
Woolich Racing Race Tools requires you to Write the ECU. It is not a stand alone product. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. You can purchase this as a package on the product page for your bike. If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply).