The Race Tools package allows you to add Autoblipper, Quickshifter, Engine Warm Up, Pit Speed Limiter and Launch Control to the Stock Yamaha FZ-10 ECU.
The package includes:
- High quality dual direction strain gauge Quickshifter with digitally controlled pressure sensing that can be used in regular or race shift pattern.
- Shift rod for standard shift configuration*
- Yamaha Race Tools Type 2 which allows the quickshifter to be plugged into the bikes wiring harness**
- Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.
Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.
Autoblipper Opening and Duration maps are fully configurable per gear.
Launch Control allows you to configure Delay, Launch RPM and Hold Speed.
Pit Speed Limiter RPM can be configured.***
Engine Warm Up parameters are configurable.***
* Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length.
** This harness uses the stock O2 plugs on the bike's harness, the stock O2 sensor should be removed from the bike and disabled in our software
*** The Pit Speed Limiter / Engine Warm Up requires the purchase of an additional Pit Speed Limiter harness
Woolich Racing Race Tools requires you to Write the ECU. It is not a stand alone product. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. You can purchase this as a package on the product page for your bike. If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply).